Right Angle Clover Leaf Power Lead 2m — Australian 3-Pin Mains Plug to Angled IEC C5, 10A Earthed Cord
An Australian mains lead ending in a right-angled IEC 60320 C5 “clover leaf” connector — the three-lobed socket used on laptop power bricks, projectors, printers and monitors. The angled connector is there for clearance: where a straight lead has to bend sharply as it leaves the brick, this one runs flat.
Check compatibility
Three round holes, not two. If the socket on your equipment has two openings in a flat oval body, that is a figure-8 (C7) and this lead will not fit it.
Key product details
- Australian compliant & approved – RCM compliance mark on the plug, approved for Australian 240V mains
- The clover-leaf end turns through 90° — the connector exits along the face of your power brick instead of straight out of it, so the lead sits flat behind a cabinet or against a wall.
- The Australian plug end is straight. Only the clover-leaf end is angled. “Right angle” on its own does not say which end carries the bend, so to be clear: the bend is at the C5.
- Australian 10 A moulded plug (AS/NZS 3112) — two angled flat pins plus a vertical earth pin.
- 2 metres of 3-core 0.75 mm² round cable, rated 10 A / 250 V, earthed through to the C5 connector.
- Fits clover-leaf equipment — laptop and notebook power bricks, projectors, printers, monitors, chargers and many console power supplies.
About this item
Only the clover-leaf end is angled — the wall plug is a normal straight one. Both kinds are sold and the phrase “right angle” does not distinguish them, so it is worth stating plainly.
2 metres, 3-core 0.75 mm², 10 A / 250 V, earthed through to the connector.
